FUEL INJECTION TEST KIT
Item number：EL0630
Description：
Gauge (0 - 300psi) x 1
Rubber test hose x 1
Steel test hose x 1
Straight steel test hose x 1
M18 x 1.5 adaptor x 1
M14 x 1.25 adaptor x 1
M12 x 1.25 adaptor x 1
M10 x 1.0 adaptor x 1
●Start engine for 10 minutes approximately or until the motor up to the temperature in normal operation
●Stop engine then disconnect the spark plug and the connecting wires. have the wires marked with number to distinguish and reconnect correctly
●Clear away the dirt around the spark plug and remove it. put them in order on a clean surface to compare compression problems according to the condition
●Remove the high-tension wires from the center of the distributor and ground them.if an electronicignition system, then disconnect the electronic ignition device or remove the primary battery terminal from the coil. if a GM hei system, then disconnect the primary wire in the distrbutor cap
●Remove air filter then fit throttle plate remember, do not damage the connector or the components on the throttle
●Choose an appropriate adapter and attach it to the head of pressure tester (speak plug hole,see fig )
●To reach easily the hole and connect to the head of the gauge, a cone rubber regulator is used to instead
